Cosmetic plastic mold housing chassis daily maintenance

Cosmetic plastic mold housing chassis daily maintenance

1. Clean the output lens:

The rear of the sight is equipped with an output lens, and it is recommended to check the surface of the lens for splash attachment after each treatment. If yes, remove the output lens and gently wipe it with anhydrous alcohol dipped in cotton swab.

2. It is recommended to change the water of the machine once after 1-2 months of use, which can increase the service life of the machine. It is forbidden to check and clean the output lens when it is turned on.

3. Add cooling water:

After 2-3 months of general use, pay attention to observing the water level of the cooling water from the water level observation hole. If the cooling water level is below the water line (off), use a syringe to fill the tank from the hole with a hole plug to the water level.

[Note] Cooling water must be distilled water! It is recommended to use hospital distilled water or other brands of pure water, remember not to use tap water or other unqualified foreign water.

4. Special instructions

The machine is provided with anti-interference measures in the software program. When the machine is started, the computer may automatically reset and the system restarts when the state is changed from the suspended state to the ready state or when the external interference is too large.

In case of accidental power failure, the software program of the machine is provided with protection function, and the machine is generally turned on after one minute.